Cretex Cove Form EP

Hygienic coving mortar for internal cornices and ceiling moulding

  • Strong adhesion for kitchen and laboratory worktops, bathroom, floor and ceiling coving
  • Facilitates easy cleaning – eliminates dirt trap
  • Easy to apply non shrink formulation
  • Functional, hygienic and attractive adhesive mix
  • Resistant to abrasion and impact damage

127.98 (ex VAT)

SKU: 1191500

Cretex Cove Form EP Product Details

Coveform EP is a non-shrink, epoxy coving mix – ideal for all hygienic areas requiring an easy clean finish. Formulated from a high strength epoxy resin, Cove Form EP gives an outstandingly strong and attractive finish.

Use on: Concrete. For other substances contact Polycote Experts
Use where: Internal/External
Typical Applications Washrooms, medical, food and laboratory areas or adjoining commercial areas prone to high levels of dusting
Type of job: Coving

Approximate coverage: 15 kg unit – 25 metres
Cure time: Recoating: 4 hours or once surface has lost tackiness
Light traffic: 6 – 8 hours
Full traffic: 24 – 36 hours
Full chemical cure: up to 7 days
Special features: Heavy duty, chemical resistant, impact resistant, abrasion resistant, can be feather edged, non-toxic, solvent-free, non-taint

Pot life:15 mins @ 200C
Application temperature:100C to 300C
Number of parts supplied:2
Priming required:No. For very porous surfaces use Polycote EP Primer.

Please consult the technical data sheet for full technical product data.

Thorough substrate preparation is essential.
Remove all loose material. Wire brushing is advisable. Sweep clean or vacuum.
The surface must be free from grease, oil or contamination. Polycote Degrease IT may be used to clean the area but this must be thoroughly rinsed off and the substrate dried, before applying Cove Form EP. Alternatively, Polycote OT Primer may be used to seal the surface from oil and/or rising damp prior to the application of Cove Form EP. Should the surface be particularly porous or weak, Polycote EP Primer has superb penetrative properties and will seal and ‘lock’ the substrate. Both primers should be allowed to fully cure before the application of the Cove Form EP. See relevant data sheets for full information.

Having fully prepared the substrate, add the whole of Part B to the whole of Part A and mix thoroughly for at least 3 minutes. For best results use a slow speed drill with a mixing paddle. Finally, pour the liquid into the large bucket and add the aggregate to the desired consistency. Ensure thorough mixing as an unmixed product will result in a poor or non-cure situation.

Apply by trowel, or by hand for small isolated areas, wearing suitable protective gloves.
Being resin-rich, Cove Form EP has a typically sticky consistency and smoothing may be assisted by wetting the trowel using Polycote Solvent Cleaner as a release agent.
If when trowelling the mortar the texture remains ‘open’ this can be easily ‘closed’ by slightly tamping the surface with the trowel. This can provide an extremely hard wearing and completely sealed surface.