Suregrip EP XFH
Excellent solution to slip hazards that can be applied almost anywhere. Ideal for stair nosings, especially where the stair is curved etc.
- Exceedingly tough
- Solvent free, non-toxic or taint
- Rapid curing: 6-8 hours (XFH version)
- Highly chemical resistant
€154.58 (ex VAT)
Suregrip EP XFH Product Details
Suregrip EP is another excellent solution to slip hazards and can be applied almost anywhere. It is particularly good on stair nosings, especially where the stair is curved or shaped differently to the standard straight edge.
Suregrip EP is a twin pack, extremely tough, epoxy resin that is blitzed with an aggregate. Being solvent free, it is non-toxic and non-taint. The aggregate supplied is calcined bauxite – the toughest material under diamonds. It will withstand constant heavy traffic and is chemical resistant. Suregrip EP can be applied anywhere and is ideal for areas where other non-slip products are not so easy to install. It is particularly good on floor to ramp joints, and stair nosings, especially where the stair is curved or shaped differently to the standard straight edge.
Solvent free, non-toxic or taint
Rapid curing: 6-8 hours (XFH version)
Highly chemical resistant
Number of parts:2
Application temperature:10oC to 25oC
Pot Life @ 20oC:20 – 25 minutes
Initial cure:8 – 10 hours
Coverage:2.5 – 5m2 per 12.5kg unit
Please consult the technical data sheet for full product technical data.
Preparation:Thorough substrate preparation is essential.
Prior to application of Suregrip EP, a suitable primer should be applied.
These include Polycote EP Primer, WD Primer or OT Primer, depending on the type and condition of the surface.
Please contact Polycote Technical Helpline, and prepare the surface in accordance with the appropriate primer data Sheet.
Having fully prepared the substrate, stir the individual components before mixing together. Add Part ‘B’ to Part ‘A’ and thoroughly mix for at least 3 minutes.
For best results use a heavy duty slow speed drill with a mixing paddle.
Ensure thorough mixing as an unmixed product will result in a poor or non-cure situation.
Apply by brush, roller or squeegee, making sure that the surface is completely covered, then completely cover the surface of the wet coating with the aggregate supplied.
Particular attention should be given to doorways and other areas of high traffic. When finished, DO NOT scrape the remaining contents from the container as this will invariably include unmixed resin.